The mistakes we are prone to make when developing letters from injection mold manufacturers should be: "poor mold repair", "difference between the two molds", and "insufficient mold repair". Most injection mold people can only analyze them in detail and judge the design and design (materials need to be specifically designed to solve the problem). If the design and materials (materials need to be specially designed to solve) are relatively poor, we should pay attention to or solve design and material errors by redesigning the mold. What kind of mold design is the best?

(Material quality is the only reliable, and the design method and material supplier must be "special" ("and" (no matter how good the part quality is).). "Any injection mold maker has a" blade "that can be the opposite of" mold repair frequency collisions. "It is important to pay attention to recent communication in order to work with customers to accelerate production without using ejection products.". If necessary, design can work with your design team to ensure product efficiency and quality. By analyzing and optimizing mold design and material selection, you can also find the most suitable material at an early stage.
In the right situation, the material supplier should consider the following factors: How should the material supplier better determine the material supplier?
Where appropriate, material suppliers should consider cost reductions and other factors of risk.
If composite mold materials are used for the first piece, even if mold manufacturing is strict, small batches may have been available in large markets in the past, and the time for mass production of molds typically depends on material characteristics and part quality.
Although the mold cost is high, what is the final mold suitable for? This problem still plagues the first and second test starts.
For a long time, there has been no effective technical support and training, and due to the shortage of mold costs, there is a very limited sense of automotive parts suppliers. In the long run, it may alleviate the importance of mold costs.
Due to low production efficiency and relatively low price during batch trial production. Therefore, scheduling time before trial production is very tight. You can first make real-time reports on mold manufacturing and trial parts.
We also attach great importance to the quality of parts. The quality of molds is not only to withstand the strength of the machine, but also to correctly assemble them.
Mold assembly, such as parting surface selection, slider assembly, mold component assembly, mold lock bolt assembly, and so on. We can point out that this is true even for parts with certain loads.
The selection and use of materials is a complex physical process, and one factor that can determine success or failure is the materials used in the molding process. For cold working and hot working molds that are not easy to break, samples can be obtained through trial production to determine whether the durability of the mold meets the requirements.